|
The Zenith amplifier range from W Audio
has
been designed and engineered to work in any demanding installation or
touring environment with military endurance.
Oversized multi-speed fans and large heat sinks will keep the output stage
cool even under the most extreme conditions. Service and maintenance is easy
as the internal architecture is laid out for easy access by qualified
technicians. Made with a heavy gauge welded steel chassis with vibration
proof fittings and an emphasis on over engineering guarantees years of
trouble free service in demanding environments.
Many amplifiers distort with both channels loaded and driven before they
hit full output power. Even some expensive "brand" name amplifiers will do
this when presented with multiple drivers at low impedance (inductive load).
The dirty signal makes it sound loud, but it will reduce speaker life. The
Zenith amplifiers are designed to handle low impedance and inductive loads
and when driven to excessive levels will "soft clip". The switchable limiter
system is controlled by a high speed VCA chip that will limit both PEAK and
RMS power to prevent clipping of the output stages.
Features:
Input Connectors: Balanced XLR, 6.35mm Jack & 5 Pin Barrier Strip
High pass line out
Low pass line out
Full range line out
Output connectors: Neutrik Speakon & Binding post
Bypass: Low pass filter - High pass filter
Indicators: Power, Signal and Clip
Stereo ( 2 ~ 8 ohm ) - Bridge ( 4 ~ 16 ohm )
Circuit Breaker Protection
Specification:
RATED OUTPUT POWER
2 ohms - 1250W x 2
4 ohms - 900W x 2
8 ohms - 540W x 2
BRIDGE MODE MONO
4 ohms - 2500W
8 ohms - 1800W
Power Supply: 240v
Dimensions:483 x 90 x 380mm
Weight: 23 kgs
ALSO INC IS THE BEHRINGER 2310 ACTIVE CROSSOVER
THE SPEAKERS
Zenith from W Audio
is the new high-end passive speaker range with single, dual-woofer and
subwoofer configuration. Zenith stands for superior performance and
reliability which is ideally suited to the installation and high power sound
reinforcement markets.
High-efficiency W Audio
full-range drivers
Robust cabinet finish
Recessed handles
Pole mount adapters
Multiple 10mm rigging
points for easy installation
Heavy-duty protective
grille
Specifications:215 SUBS
Frequency range (-10dB):
35Hz-800Hz
Frequency range (-3dB):
45Hz-1000Hz
Max Calculated SPL: 135dB
Rated System Power: 1000W
Continuous 4000W Peak
Low Frequency transducer: 2
x 15"/381mm
Nominal Impedance: 4 Ohms
Connector: 2 x NL4 Speakon
Dimensions: 915mm x 585mm x
700mm
Weight: 74Kg
Specifications:112 TOPS
Frequency range (-10dB): 50Hz-20kHz
Frequency range (-3dB): 60Hz-20kHz
High pass frequency: 25Hz
Max Calculated SPL: 128dB
Horizontal coverage: 90 degrees
Vertical coverage: 60 degrees
Rated System Power: 300W Continuous 1200W Peak
Crossover Frequency: 2.0kHz
Low Frequency transducer: 12"/305mm
High Frequency transducer: 1"/26mm
Nominal Impedance: 8 Ohms
Connector: 2 x NL4 Speakon
Dimensions: 656mm x 405mm x 415mm
Weight: 30Kg
£2,059.00 |
